Twisted Traces Logo
1-630-345-5400 0 Wishlist 0 My Cart
PCB Online Quote
PCB Services
PCB Assembly Quick Turn PCBs Assembly PCB Box Build Assembly
PCB Fabrication Standard PCBs RoHS Compliant PCB Printed Circuit Board Design Flexible Circuit Board Rigid-Flex PCBs
PCB Manufacturing Services
Capabilities
PCB Accepted Standards PCB Aspect Ratio PCB Board Size PCB Bow and Twist PCB Controlled Impedance PCB Copper Thickness PCB Layers
PCB Materials PCB Minimum Annular Ring PCB Modification PCB Profile PCB Repair Services PCB Silkscreen PCB Solder Mask Colors
PCB Stack-ups PCB Surface Finishes PCB Thickness PCB Tolerances PCB Trace Width Clearance PCB Prototype
Resources
Blog
FAQ
PCB Industries Served
About Us Contact Us
Get a Quote
  1. Home
  2. Capabilities
  3. PCB Bow and Twist

PCB Bow and Twist

Bow and twist are the two characteristics used to determine the flatness of printed circuit boards. The bow condition is a spherical or cylindrical curvature of the board, when its four corners lie in the same plane. However, twist is the condition where the deformation lies parallel to the diagonal of the circuit board. This means one corner is different than the other three corners. As per the IPC-A-600 standard, all boards should have bow and twist less than 1.5%. For boards with SMD components, the bow and twist values should be less than 0.75% or less. At Twisted Traces, we provide printed circuit boards with SMT values ≤0.75%, and non-SMT values ≤1%.

PCB Bow and Twist

Steps Taken To Avoid Bow And Twist

Bow and twist is affected by the board designs. Material properties and board thickness are the two other factors influencing the board design. At Twisted Traces, PCB designing and assembly is handled by qualified and expert PCB designers. They take the following steps to avoid bows and twists:

  • A symmetrical build-up of copper thicknesses, pre-pegs, and cores is selected in the PCB manufacturing process. The risk of bows and twists is high in multilayered circuit boards. This risk is minimized by adding pre-peg to the mix.
  • All base materials are selected keeping RoHS compliance in mind. We take care to work with materials that are ideal for lead-free soldering.
  • During the construction of a multilayer circuit board, we organize a balanced stack-up of layers. We always we use two laminates that are affected differently by thermal processes. Balanced stack-up helps oppose thermal expansion values of laminates against each other, and maintains an even bow and tie arrangement.
  • Copper distribution is the key factor that we concentrate upon. Unbalanced copper weights have negative impact on bow and twist. If there are areas with low or high density copper distribution, our designers add copper to balance the low density areas.
  • In multilayer PCBs, plane and signal layers are arranged symmetrically around the center of PCB. This is because solid layers expand differently than signal layers, when the signal density is light.
  • We avoid mixing materials from different vendors.
  • Special attention is given to lay up the material warp and weft appropriately.
  • We use proper parameters of pressing in multilayers to reduce the stress on the PCB.
  • We understand that heavy thermal shocks during soldering may cause bows and twists. This is why we avoid it during the soldering process. Hence, we only use a suitable soldering process. Also, the soldering process is supported with adequate support.

To know more about our printed circuit board capabilities, please click here. For more details, please call us on (630) 345-5400 or email us at quotes@twistedtraces.com.